With our renown 6-place IntelliVox® automatic Voice Operated Relay (VOX) intercom system,  adjusting a squelch circuit is a thing of the past. And with over 13 years of field experience, find out just how easy it is to forget you are even using an intercom, it just works! No more clipping or missed syllables. 

The PMA7000B provide 3-com capability with the option to easily convert Com 3 to a full duplex cellular telephone interface.  Click here for List of Cell Phones. It also has our pioneered "Split Mode". This allows the pilot to be on Com 1 while the copilot is on Com 2, freeing up the pilot to work with ATC while the copilot gets weather information or finds out just where the lowest fuel cost is on the field while still in the air.

Check list of capabilities:

• IntelliVox® automatic VOX system with individually gated microphones

• 6 - Place hi-fi stereo intercom with Soft Mute™

• 2 - music mute modes: Mute On and Mute Off

• Built-in Marker Beacon Receiver

• Cellular telephone input with dedicated On/Off hook switches for unprecedented flexibility

• Split mode for dual audio panel capability

• 2  hi-fidelity stereo music source inputs 

• 3 - Isolation modes - Pilot Isolate, All, and Crew

• 4 - unswitched inputs

• Selectable music muting for passengers

• Selectable special intercom mode with  "Alternate Intercom Mode"

• RAM (Radio Active Mute) eliminates constant back ground noise from radio static

• 2-year Pro-Support Warranty

The only knob that is on the panel is a concentric volume control for the Crew  and Passengers intercom volume. The all push button controls of the PMA7000B allows for easy selection of Coms and other Nav aids.  

The PMA7000B has four un-switched and un-muted inputs. This adds flexibility when installed with today's advanced warning systems, like Skywatch or TAWS.

Here are the steps it takes to replace a KMA24 with a PMA7000B:

1) remove KMA24 from tray
2) remove the connector from KMA24 tray

4) remove tray
4) install PMA7000B tray
5) install connector in PMA7000B tray

6) install PMA7000B into tray

As far as the audio panel installation is concerned, its done.  GO FLY

BUT.........

You will not have any intercom functions until that portion of the install is completed.

That's why  there is  second connector. This connector must be wired by your avionics shop that will provide all of the intercom functions, telephone interface, and music inputs.

The PMA7000B is plug and play with the original PMA7000M-S, the PMA6000M-S, and the KMA28.